How do you heat a DynaVap vaporizer?
We recommend that you use a butane torch lighter for optimal results. To ensure even heating, apply the heat to the cap, away from the end, and rotate the device steadily until you hear/feel a click. Directly heating the end of the cap will cause it to click prematurely, causing reduced vaporization.
DO NOT apply heat past the click. Overheating will permanently damage the cap.
With a torch lighter and a titanium tip, the typical heat-up phase takes 3-6 seconds and remains at vapor production temperature until the cool-down click about 30 seconds later. After the cool-down click, it is safe to begin another heating cycle. When using a soft flame lighter, the heat-up phase takes about 15 seconds. The stainless steel tip requires a longer heat-up time than the titanium tip.
You can also heat your device with an Induction Heater
Tip: The Wand can be used with or without the DynaVap adapter, comes preloaded with all Wand units. The adapter provides a hands-free experience. If you want to use the Wand as a tabletop device then the adapter would be the accessory for you. The adapter holds the devices straight up and down without holding your DynaVap in the heating chamber during a session.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article