How to clean your DynaCoil

You will need:
Isopropyl Alcohol - the higher % the better
Water tight container
Your dirty DynaCoil

To remove the dirty Dynacoil

• Remove the tip and cap
• Set the cap and stem to the side
• Fill the container with alcohol 
• Put the tip and coil into the container with liquid
• give it a good shake and let it sit for a few hours
  after a few hours, the solution should break up the residue 
• Rinse the tip and coil with warm water
• Use your digger outer side of your cap to remove the condenser from the stem        The condenser will be the tool to help remove your DynaCoil
• Slowly insert the condenser into the bottom of your tip with your finger covering the top opening of the tip. 
• Gently push, if you push too hard you can potentially uncoil the DynaCoil. If the coil is still difficult to remove try soaking it longer. 
• Once the coil is removed let just the coil soak for a few more hours or until clean.

You will notice some discoloration on the coil, just like any metal you heat up you will notice some patina build-up but this will not affect the performance.