Yes you sure can!

Looking to enjoy concentrates with your DynaVap “B”? The DynaCoil offers a compact, torch-friendly way to elevate your session without adding a bunch of gear. Think of it as your no-fuss dab rig, minus the rig.

What You’ll Need

• DynaVap “B”

• DynaCoil

• Your favorite concentrate

• A heat source (torch, induction heater, etc.)

Step-by-Step: DynaCoil Setup

1. Disassemble Your “B”

• Remove the Cap and Tip

• Push the condenser out of the stem

• Remove the CCD from the tip

2. Insert the DynaCoil

• Insert the coil Teeth Side out (you’ll see a flat edge)

• If needed, bend the small corner on the coil slightly outward for a snug fit

• Press the coil into the tip until it clicks into place

3. Reassemble the “B”

• Slide the condenser and tip back into the stem

• You’re ready to heat

Heating + Loading Concentrates

1. Preheat the Tip (Not the Coil)

• Aim your flame at the fin, not directly at the coil

• Heat until the tip is warm enough to melt concentrates, not glowing hot

2. Load the Coil

• Dip the warm coil into your concentrate

• The concentrate will melt and soak into the coil’s porous surface

3. Final Heating + Extraction

• Cap the device

• Heat below the base of the tip

• Wait for the click, then enjoy your flavorful vapor

Why It Works

The DynaCoil holds and vaporizes concentrates evenly without excess heat or mess. It’s a pocket-sized setup for clean, powerful hits—no tools required.

Watch below for a demonstration for using the DynaCoil for concentrates with your B tip!